An Introduction to 6×9 Speakers

If you’re looking to buy a set of 6X9 speakers for your car, there are some things you have to know to make an educated evaluation. There are several review sites online which will give you good information.

One of the most recognizable questions asked with regards to 6X9 car speakers and jargon you will surely fall upon when shopping, is “What does 2-way, 3-way and 4-way 6×9 car speakers mean?” Looking at a 3 way car speaker as a case in point, it just refers to the amount of drivers a loudspeaker uses to create sound. The 3-way configuration incorporates a tweeter for high frequencies, a woofer for low frequencies, and a mid-range driver. Each speaker has at least 3 different drivers to produce the array of frequencies. A 3 way configuration is extremely common among speakers and is used by a diversity of producers.

A 2-way 6×9 car speaker just uses a woofer and tweeter, while a 4-way has more particular computer configurations for example tweeter, high mid range, low midrange and woofer for bass. It’s often considered quintessential to have dedicated drivers; however, the quality of the loudspeaker’s make and design will also be a significant factor in the speaker’s functionality. Finally you’ve got the final say in determining what suits your requirements the best. In actuality, a 4-way 6×9 car speaker is not necessarily better than a 3-way and a 3 way isn’t automatically superior than a 2-way.

A prevalent misconception is that while 3-way loudspeakers operate drivers for low, mid and high frequencies, the term doesn’t inevitably entail that no more than 3 devoted drivers are used by the speakers. Numerous drivers are incorporated by many 6×9 car speakers for each frequency. A 3 way loudspeaker could have a significantly larger variety of drivers than 3. Added drivers are used to enhance performance of the loudspeaker and consequently these kinds of speakers normally will be more expensive.

Here are three additional aspects that need to be considered while shopping for 6X9 car speakers. These are what I deem to be critical when making an evaluation on what to purchase, while there are more.

Frequency Response: This is the measure of the audible spectrum a loudspeaker can mimic. The greater the frequency range, the better, up to 20kHz and down to 20Hz.

Power Handling: This is the amount of power a loudspeaker can handle before weakening after a stated timeframe. The most remarkable amount is the speaker’s continuous or RMS (root mean square) power handling. Continuous power ratings are a basic of functionality specifications. Peak power handling is the finest amount of power measured during a given amount of time and is frequently substantially greater than the RMS. RMS power handling is a more valuable measurement to search for.

Susceptibility: A speaker’s sensitivity rating, occasionally called efficacy, tells you how efficiently the loudspeaker converts electricity into sound. The higher the number, the more proficient the loudspeaker, and the louder the sound it creates. An effective speaker helps you take advantage of your wattage that is available. An appealing aspect to note – a 3 decibel increase in loudspeaker sensitivity fabricates the same audible boost in volume as doubling your amplifier electricity. It is always a superb idea to check the sensitivity specification when shopping for loudspeakers, especially if you’ve got a lower-powered receiver or amp.

Using this knowledge hopefully will help you to make the correct choice in your new set of 6X9 car speakers. It is always a good thing to equip yourself with the appropriate information before buying anything, and as it pertains to speakers for your car, this much holds true.